Labconco Bulk Powder Stations 3962622 - Manual (Page 26)

Chapter 5: Using Your Enclosure
Product Service 1-800-522-7658 22
Loading Materials and Equipment
 For hazardous powders, prepare the source container with the safety sleeve
and retaining band as shown in Figure 5-1 and 5-2.
 Position all sizes against the stop.
 Push cart into lift until it is latched. (Figure 5-2)
 Raise and secure the top of the safety sleeve on the source container to the
work surface with a retaining band as shown in Figure 5-3, 5-4 and 5-5.
 Select a retaining ring (up to 19.62" dia.), which is slightly larger than the
diameter of your container. Fasten the retaining ring to the work surface with
the 1/4 turn fasteners. Secure it with a retaining band as shown in Figure 5-6
and 5-7. If source lid is too large, remove before installing retaining ring.
Figure 5-6 Figure 5-7
¼ turn fasteners
Source Container Lid
Figure 5-1
Retaining Band
Safety Sleeve
Stop
Figure 5-2
Electric Lift Switch
Cart Latch
Figure 5-3 Figure 5-4 Figure 5-5
Lower Retaining Ring
Upper Retaining
Ring