Labconco Bulk Powder Stations 3962622 - Manual (Page 13)

Product Service 1-800-522-7658 9
Chapter 3
Getting Started
Now that the site for your XPert Bulk Powder Enclosure is properly prepared, you
are ready to unpack, inspect, install, and validate your system. Read this chapter to
learn how to:
 Unpack and move the enclosure.
 Set up the enclosure with the support lift stand and work surface.
 Connect to an exhaust system (if necessary).
 Connect the electrical supply.
 Set the face velocity.
 Seal the enclosure to the work surface.
 Arrange validation for the enclosure.
Depending upon which model you are installing, you may need common plumbing
and electrical installation tools in addition to wrenches, ratchets, sockets, a nut
driver set, a flat-blade screwdriver, a Phillips screwdriver, and a carpenter level to
complete the instructions in the chapter.
The upper portion of the enclosure models with attached work
surfaces weigh between 100 to 550 lbs. each (45 to 248 kg). The
lift stands weigh between 380 to 500 lbs. each (171 to 225 kg).
The shipping container allows for lifting with a mechanical lift
truck or floor jack. If you must lift manually, follow safe-lifting
guidelines.
Do not lift by the front or side air foils .
!