Labconco Bulk Powder Stations 3962622 - Manual (Page 33)

Chapter 7: Accessorizing Your Enclosure
Product Service 1-800-522-7658 29
3.
Retaining Rings
Retaining rings mount to the work surface to secure the inner source container
bags and/or safety sleeve. They are manufactured from type 304 stainless steel
and are easily cleaned. Ideally, the inner diameter of the retaining ring should
be slightly larger than the diameter of the source container to permit lid
removal in the enclosure and a minimum of 2" smaller than the source
container’s inner bag diameter.
Catalog # Description
3981300 Retaining Ring 19.62" ID
3981301 Retaining Ring 17.50" ID
3981302 Retaining Ring 14.50" ID
3981303 Retaining Ring 11.50" ID
3981304 Access Opening Cover (Provides a solid work surface)
4.
Fluorescent Light Kits
A fluorescent task light rests on top of the enclosure; more than one may be
used. It is only for use on XPert Bulk Powder Enclosures. (XPert Bulk Powder
Filtered Systems and Stations already have a built-in fluorescent light).
Catalog # Description
3909200 18" W x 10.12" D x 3" H Light Kit, 115V 60Hz
3909201 18" W x 10.12" D x 3" H Light Kit, 230V 50Hz
5.
Exhaust Transition Adapters
Exhaust transition adapters connect to the top of the XPert Bulk Powder
Enclosures without built-in HEPA filters. A dual exhaust connector is available
for connecting multiple exhaust connections (8" x 6" x 6" Tee) for the 8' units
since the 8' models use two exhaust outlets. See Chapter 3 for a view of these
exhaust transition adapters. Figure 3-2 and Figure 3-3.
Catalog # Description
3912401 Upper Exhaust Transition, 6.03" ID, 6.09" OD Epoxy coated steel
3912400
Upper Exhaust Transition, 4.94" OD epoxy coated steel used to
connect FilterMates. Each FilterMate supplied with one.
3981600 Dual Exhaust Tee 6" x 6" x 8", for use on 8' models to convert
the two 6" exhaust outlets to one 8". Used in combination with
two 3912401 Upper Exhaust Transitions.