Labconco Fiberglass 30 Laboratory Fume Hoods 3030005 User Manual
Page 13
9
Product Service 1-800-522-7658
C
C
H
H
A
A
P
P
T
T
E
E
R
R
3
3
G
G
E
E
T
T
T
T
I
I
N
N
G
G
S
S
T
T
A
A
R
R
T
T
E
E
D
D
Now that the site for your laboratory fume hood is
properly prepared, you are ready to unpack, inspect,
install, and certify your unit. Read this chapter to learn
how to:
• Unpack and move your Fiberglass 30 Hood.
• Set up the fume hood with the supporting
structure and work surface.
• Connect to an exhaust system.
• Connect the electrical supply source.
• Connect the service lines.
• Seal the Fiberglass 30 Hood to the work surface.
• Arrange certification of your Fiberglass 30
Hood.
Depending upon which model you are installing, you
may need common plumbing and electrical installation
tools in addition to 5/16", 3/8", 7/16", and 1/2"
wrenches, ratchets, sockets, a nut driver set, a flat-blade
screwdriver, a Phillips screwdriver, and a carpenter
level to complete the instructions in the chapter.
Unpacking Your Laboratory
Fume Hood
Carefully remove the shrink-wrap or carton on your
fume hood and inspect it for damage that may have
occurred in transit. If your unit is damaged, notify the
delivery carrier immediately and retain the entire
shipment intact for inspection by the carrier.
The United States
Interstate Commerce
Commission rules
require that claims be
filed with the delivery
carrier within fifteen (15)
days of delivery.