Labconco Fiberglass 30 Laboratory Fume Hoods 3030005 - Manual (Page 15)

11
Product Service 1-800-522-7658
Chapter 3: Getting Started
Removing the Shipping
Skid
LEAVE THE FUME HOOD
ATTACHED TO ITS SHIPPING SKID
UNTIL IT IS AS CLOSE TO ITS
FINAL LOCATION AS POSSIBLE.
MOVE THE HOOD BY USING A
SUITABLE FLOOR JACK, OR BY
PLACING A FURNITURE DOLLY
UNDERDNEATH THE SKID. DO
NOT MOVE THE HOOD BY TILTING
IT ONTO A HAND TRUCK.
After you verify the fume hood components, move your
hood to the location where you want to install it.
Sash Weight Release
To protect the fume hood from damage in shipment, the
sash weight has been secured to the back of the fume
hood with four (4) screws. Simply remove the screws
and make sure the sash cables are on the pulleys before
operation of the sash.
NOTE: THE SASH WEIGHT IS MATCHED
TO THIS SPECIFIC HOOD AND SHOULD
NOT BE EXCHANGED ON ANY OTHER
UNIT.
Install the Fiberglass 30
Hood on a Supporting
Structure and Work Surface
The Fiberglass 30 Hood is heavy! Use
caution when lifting or moving the
unit.
When installing the Fiberglass 30 Fume Hood onto a
chemically resistant work surface or benchtop, ensure
)
!
)