Installing additional service fixtures – Labconco Fiberglass 30 Laboratory Fume Hoods 3030005 User Manual
Page 40
36
Product Service 1-800-522-7658
Chapter 7: Modifying Your Fiberglass 30 Fume Hood
Installing Additional Service
Fixtures
Additional service fixtures can be installed in the
available service fixture holes in the right sidewall and
corner post. The fume hood is factory set to accept up
to three valves. Contact Labconco Customer Service
for information. The following service fixture kits are
available:
2832600
Cold Water (CW) – Green
2832601
Hot Water (HW) – Red
2832602
Deionized Water (DW) – White
2832603
Vacuum (VAC) – Yellow
2832604
Air (AIR) – Orange
2832605
Gas (GAS) – Blue
2832606
Nitrogen (NIT) – Brown
2832607
Argon (ARG) – Gray
2832608
Steam (STM) - Black
Installing Guardian™ Digital
Airflow Monitor or
Guardian™ Jr. Airflow
Monitor
The Guardian Digital Airflow Monitor P/N 9743201
and 9743205 or Guardian Jr. Airflow Monitor P/N
9743202 and 9743206 allows you to continuously
monitor face velocity through the fume hood opening.
The fume hood right corner post is factory prepared to
mount either monitor. Contact Labconco Customer
Service to order.
Figure 7-3 – Hose Connector
Figure 7-1 - Knob
Figure 7-2 – Valve