Labconco Fiberglass 30 Laboratory Fume Hoods 3030005 User Manual
Page 14
10
Product Service 1-800-522-7658
Chapter 3: Getting Started
DO NOT RETURN GOODS
WITHOUT THE PRIOR
AUTHORIZATION OF LABCONCO.
UNAUTHORIZED RETURNS WILL
NOT BE ACCEPTED.
IF YOUR HOOD WAS DAMAGED IN
TRANSIT, YOU MUST FILE A
CLAIM DIRECTLY WITH THE
FREIGHT CARRIER. LABCONCO
CORPORATION AND ITS DEALERS
ARE NOT RESPONSIBLE FOR
SHIPPING DAMAGES.
Do not discard the shipping skid or packing material for
your fume hood until you have checked all of the
components and installed and tested the unit.
Do not remove the fume hood from its shipping skid
until it is ready to be placed into its final location.
Move the unit by placing a flat, low dolly under the
shipping skid, or by using a floor jack.
THE FIBERGLASS 30 HOOD
MODELS WEIGH BETWEEN 96 TO
129 LBS. (44-59 KG). THE
SHIPPING SKID ALLOWS FOR
LIFTING WITH A MECHANICAL
LIFT TRUCK OR FLOOR JACK. IF
YOU MUST LIFT THE FUME
HOOD MANUALLY, FOLLOW
SAFE-LIFTING GUIDELINES.
NORMALLY, THE FUME HOOD
CAN BE SLID OFF A HYDRAULIC
LIFT TABLE AND BE PLACED
INTO POSITION ON TOP OF THE
WORK SURFACE.
DO NOT
LIFT BY THE FRONT AIR
FOIL
.
Do not move the hood by tilting it onto
a hand truck.
!
!
)
)