Rocktron Replifex - Manual (Page 24)

21
Functions and Parameter Descriptions
This parameter is used to select whether the Source 2 input will be the
VOICE 2 output from the previous effect in the signal chain or the
direct signal. In configurations where there is no effect immediately
preceding the delay, both Source 1 and Source 2 will be the direct
signal.
The DELAY HIGH FREQUENCY DAMPING parameter controls the
amount of high frequency content in the delayed and regenerated
signals. Higher amounts of damping will result in less high frequency
information in the delayed signal.
The DELAY OUT 1 parameter determines the volume of Delay 1.
The DLY PAN1 parameter allows you to pan the Delay 1 signal to the
left or right channel.
The DELAY TIME1 parameter determines the length of time (in
milliseconds) after the input signal that the Delay 1 signal will begin.
The DELAY TIME can be adjusted via the PARAMETER ADJUST
control, MIDI controller changes or via the Tap Delay feature.
The FINE 1 parameter allows for adjustment of Delay 1 in 1 millisec-
ond increments.
The DLY RGN 1 parameter determines how many times the Delay 1
signal is fed back into the input and repeated.
The DELAY OUT 2 parameter determines the volume of Delay 2.
The DLY PAN2 parameter allows you to pan the Delay 2 signal to the
left or right channel.
The DELAY TIME2 parameter determines the length of time (in
milliseconds) after the input signal that the Delay 2 signal will begin.
The DELAY TIME can be adjusted via the PARAMETER ADJUST
control, MIDI controller changes or via the Tap Delay feature.
The FINE 2 parameter allows for adjustment of Delay 2 in 1 millisec-
ond increments.
The DLY RGN 2 parameter determines how many times the Delay 2
signal is fed back into the input and repeated.
The SPILLOVER parameter determines whether delays from the
current preset will "spill over" into the next preset when it is recalled.
SOURCE 2
DLY HF DAMP
DELAY OUT 1
DLY PAN1
DLY TIME1
FINE 1
DLY RGN 1
DELAY OUT 2
DLY PAN2
DLY TIME2
FINE 2
DLY RGN 2
D>SPILLOVER
Note!
When delays from the
current preset are spilled
over into the next preset
recalled (i.e. SPILLOVER
"ON"), the delay parameters
for the new preset will be
changed to match those of
the previous preset (except
for the DELAY I/O and
SPILLOVER parameters) -
even if the Delay effect is
switched "OUT" in the
previous preset.
The EFFECT LEVEL
parameter in the next preset
recalled does not change,
therefore delays spilled into
it may be of higher or lower
volume - depending on the
EFFECT LEVEL setting in
each preset.
Also, recalling the same
preset twice via MIDI will
cancel the Spillover effect
and reset the new preset to
its stored parameter values
(only when the SPILLOVER
parameter in the recalled
parameter is set "OFF").
!