Rocktron Replifex - Manual (Page 40)

37
Operating the Replifex ™
Switching Channels on Amplifiers and Preamps via the Replifex ™ *
The Replifex ™ allows you to switch channels on an amplifier or preamp by connecting a RTS cord from
the "CHANNEL SWITCH" jack on the rear of the Replifex ™ to the "FOOTSWITCH" jack on the remote device(s).
A single stereo-to-dual mono cord can also be used to connect from the Replifex ™ to two separate units. This
allows for channel switching to be programmable (i.e. switched automatically when a Replifex ™ preset is
recalled) instead of having to use a latching footswitch each time a channel needs to be switched. This
function can also be performed through programming a continuous controller to the CHAN SW parameter(s).
See page 41, "Controller Assignments" for more information on assigning continuous controllers.
Step 3 Use the PARAMETER ADJUST control to select the on/off condition of Channel Switch 1.
When switched "ON", the channel connected to the Tip of the Replifex
™ CHANNEL
SWITCH jack will be switched when the current preset is recalled.
CHAN SW 1 ON
Step 2 Turn the PARAMETER SELECT control one step clockwise to "CHAN SW 1".
CHAN SW 1 OFF
Step 1 Turn the FUNCTION SELECT control to "CHANNEL SWITCHES".
CHANNEL SWITCHES
4,7 2,5 1 3,6
The Tip of the "CHANNEL SWITCH" jack sends the change for Channel
Switch 1, while the Ring of the "CHANNEL SWITCH" jack sends the change
for Channel Switch 2. When Channel 1 is on, the Tip is connected to the
Sleeve. When Channel 2 is on, the Ring is connected to the Sleeve. When
Channels 1 and 2 are both off, the Tip and Ring are an open circuit with
respect to the Sleeve (see diagram).
SLEEVE
RING
TIP
Ch. 2
Ch. 1
* This feature was designed to operate with as many different amplifiers as possible. However, due to the large
number of amplifiers available on the market, it cannot be guaranteed to be compatible with all amplifiers.