Rocktron Replifex - Manual (Page 9)

6
4. Rear Panel 4. Rear Panel
1 Left and Right INPUT jacks
These ¼" mono jacks provide inputs to the left and right channels
of the Replifex
™ . When using only one input, the Right (R) jack
should be used.
2 Left and Right OUTPUT jacks
These ¼" mono jacks provide outputs from the left and right
channels of the Replifex
™ .
When using a mono input (Right channel INPUT jack) and a mono
output (either OUTPUT jack), the left and right effected signals
will be summed at the single output.
3 Tap Delay/Rate FOOTSWITCH jack
This ¼" mono jack is provided for the connection of a momentary
footswitch to control the Tap Delay feature of the Replifex
™ .
4 CHANNEL SWITCH jack
This ¼" stereo jack can be connected to the channel switching
footswitch jack on an amplifier or preamp. This allows for pro-
grammable channel switching directly from the Replifex
™ .
.
5 PHANTOM POWER jack
This 2.5mm PIN jack offers the ability to power Rocktron MIDI
foot controllers from a 7-pin MIDI cable which connects from the
Rocktron MIDI foot controller to the MIDI IN jack on the rear
panel of the Replifex
™ . This eliminates the need to find an AC
outlet near where the footpedal would be placed during a perfor-
mance, or the need to run an extension cord out to the footswitch.
Instead of inserting the AC adaptor into the "POWER" jack of the
footswitch as you would normally, plug it into the "PHANTOM
POWER" jack on the Replifex
™ . This will power the Rocktron
MIDI foot controller through pins 6 and 7 of the MIDI cable
connecting the two units. A 7-pin MIDI cable must be used and is
available from your Rocktron dealer.