Rocktron Replifex - Manual (Page 32)

29
Functions and Parameter Descriptions
The next function displayed when turning the FUNCTION SELECT control is
the Auto Pan function. The Auto Pan effect auomatically pans between left and
right when operating in stereo mode. (If operating in mono, the Auto Pan effect
does not operate.)
The PARAMETER SELECT control will allow you to access each of the following
Auto Pan parameters:
AUTO PAN
Function
The AUTO PAN I/O parameter determines whether the auto pan circuit
is active or bypassed for the current preset.
The LOCATION parameter determines what part of the signal path is
affected by Auto Pan - Direct Only, Effects Only or Both.
The AUTO PAN RATE parameter determines the speed at which the
signal is panned between the Left and Right channels.
The AUTO PAN WIDTH parameter determines the intensity at which
the signal is panned between the Left and Right channels.
The TIME parameter determines the multiplier by which a new
modulation rate will be selected for the RATE parameter when the Tap
Delay feature of the Replifex
™ is used. (See Section 7: "Tap Delay" for
more information on the Tap Delay feature.)
AUTO PAN I/O
LOCATION
APAN RATE
APAN WIDTH
TIME