Rocktron Replifex - Manual (Page 49)

46
Operating the Replifex ™
Step 6 After flashing "STORED", the Replifex ™ will display "COPY TITLE TOO?". This allows
you to copy the title from the copied preset into the new location as well. To copy the title,
press the STORE button a second time. "STORED" will flash briefly before the Replifex
™
displays the new preset number and title.
Turning the PARAMETER ADJUST control instead of pressing the STORE button allows
you copy the title from the preset being copied to any other location. Once a location has been
selected, press the STORE button to copy the title.
If you do not wish to copy the preset title, turn the PARAMETER SELECT or FUNCTION
SELECT control to exit the preset copy function. The preset has been copied to the new
location, but its title will be the title which was already at the new location.
STORED
Copying preset titles:
Step 1 Turn the FUNCTION SELECT control to "COPY".
SSSS COPY SSSS
Turn the PARAMETER SELECT control two steps clockwise to access the "TI> XX to >TI
XX" parameter, as shown below. The number on the left represents the preset title to be
copied, while the number on the right represents the preset location to copy the title to. Step 2
TI> 4 TO >TI 4
Preset location to copy to Preset title to copy
Use the PRESET control to select the desired preset title to be copied.
TI> 21 TO >TI 4
Step 3
Use the PARAMETER ADJUST control to select the location to copy the selected preset into. Step 4
TI> 21 TO >TI 59