Rocktron Replifex - Manual (Page 67)

64
Using the Replifex ™ with a Rocktron All Access ™ in REMOTE mode
A Rocktron All Access ™ MIDI footswitch can be configured as a dedicated remote control for the
Replifex ™ - allowing direct access to specific Replifex ™ features and parameters from the footswitch at any
time.
To use an All Access ™ footswitch as a dedicated remote, connect the MIDI OUT of the All
Access ™ to the REMOTE jack of the Replifex ™ using a 7-pin MIDI cable, as shown below.
Step 1
Step 2 Reinitialize the controller assignments as shown on page 62 under the heading "Restoring the
Replifex
™ Controller Assignments". This will match up the Replifex's controller assignments
to the All Access ™ . A code of "244" must be entered to initialize only the controller
information.
ALL RESTORE 244
To set up the Replifex ™ for remote operation, do the following:
Operating the Replifex ™