Applied Motion SV7-C-CE - Manual (Page 6)

6
SV7 Hardware Manual 920-0012F
12/18/2014
Getting Started
This manual describes the use of three different drive models. What you need to know and what
you must have depends on the drive model. For all models, you’ll need the following:
• a 24 to 80 volt DC power supply. Please read the section Choosing a Power Supply for help
in choosing the right power supply.
• a compatible motor (see Recommended Motors)
• a small flat blade screwdriver for tightening the connectors (included).
• a personal computer running Windows 98, 2000, NT, Me, XP, Vista or 7. 32 or 64-bit.
• Applied Motion software (available for free download at www.applied-motion.com/software)
• An Applied Motion programming cable (included with non-Ethernet drives).
• For Ethernet drives you will need a CAT5 cable (not included).
If you’ve never used an SV drive before you’ll need to get familiar with the drive and the set
up software before you try to deploy the system in your application. We strongly recommend the
following:
1 For -S drives, download and install the QuickTuner™ software application.
For -Q and IP drives, download and install QuickTuner™ and Q Programmer™.
For -Si models, install and use the Si Programmer™ software for configuration and programming.
For -C drives, install the QuickTuner™ and the CANopen Example Program software.
Q Programmer™ software may also be installed, if needed.
3 Launch the software by clicking Start...Programs...Applied Motion...
4 Connect the drive to your PC using the programming cable.
5 Connect the drive to the power supply.
6 Connect the drive to the motor.
7 Apply power to the drive.
8 For RS-232 connections, the software will recognize your drive, display the model and firmware
version and be ready for action.
9 For Ethernet drives, once the proper IP address has been entered, the software will recognize
your drive, display the model and firmware version and be ready for action.