Paxton Superchargers Dodge Viper RT/10 - Manual (Page 11)

2-1
P/N: 4809646
©2006 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
17FEB06 v2.0 92-96Viper(4809646v2.0)
Section 2
OIL FEED
A. Remove the oil pressure sender from the
front passenger side of the engine directly
above the oil filter.
B. Install the 1/8"NPT TEE in the oil sender
hole. Leave the TEE pointed up. Install the
1/8"NPT x -4 90° fitting in the top of the
TEE. Install the oil pressure sender in the
front hole in the TEE and re-attach the elec-
trical plug. (See Fig. 2-a.)
C. Temporarily cover one end of the oil feed
line and protect it from debris until connect-
ing it to the supercharger.
D. Connect the open end of the oil feed line to
the -4 fitting. Use tie-wraps to secure the
line and protect it from kinking, abrasion
and high heat areas.
***IMPORTANT***
Use clean engine oil on the pipe threads. Teflon tape
and sealant is NOT recommended as it might loosen
and cause blockage of the small oil feed orifice result-
ing in supercharger failure.
2. OIL FEED
Fig. 2-a