Paxton Superchargers Dodge Viper RT/10 - Manual (Page 19)

6-1
P/N: 4809646
©2006 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
17FEB06 v2.0 92-96Viper(4809646v2.0)
Section 6
SUPERCHARGER MOUNTING BRACKET INSTALLATION
6. SUPERCHARGER MOUNTING
BRACKET INSTALLATION
A. Install the supplied mounting bracket onto
the head using the factory power steering
bracket screws.(See Fig. 6-a.)
***NOTE***
Mounting bracket/spacer to shock tower support clear-
ance may be too small on some vehicles. Lightly sand
one or both parts until 3/16" clearance is achieved.
B. Using the three supplied spacers (not used
on 1996 vehicles, put spacers under bolt
heads for proper thread engagement)
between the power steering pump and the
mounting bracket, install the pump using the
factory bolts. (See Fig. 6-b.)
C. Install the supplied -6 x 18mm adapter into
the high pressure port on the power steering
rack. Install the supplied -6 x 16mm adapter
into the pump, attach the supplied power
steering hose to the pump so that it is routed
towards the passenger’s side. (See Fig. 6-c.)
Route the free end of the hose around the
mounting bracket and attach to the power
steering rack.
D. Secure the power steering lines away from
contact with sharp or moving objects using
the supplied zip-ties.
Fig. 6-a | '93 Vehicle Shown, See Text)
Fig. 6-c
Fig. 6-b
FACTORY BOLT
SUPPLIED SPACER