Paxton Superchargers Dodge Viper RT/10 - Manual (Page 21)

7-1
P/N: 4809646
©2006 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
17FEB06 v2.0 92-96Viper(4809646v2.0)
Section 7
ALTERNATOR RELOCATION ASSEMBLY
7. ALTERNATOR RELOCATION
ASSEMBLY
A. Remove the alternator bracket fron the vehi-
cle.
B. Remove the alternator, alternator bushing,
idler pulley and the spring tensioner from
the bracket.
C. Assemble the supplied alternator plates onto
the engine as shown. (See Fig. 7-a.) Install
the spring tensioner and idler pulley in their
respective locations.
D. Using the original alternator bolt installed
through the bushing, install the alternator
and belt in the original configuration but
leave the belt loose on the spring tensioner.
Fig. 7-a | Alternator and spring tensioner not shown
Fig. 7-b | Alternator & tensioner not shown
FACTORY ALTERNATOR BUSHING
4PCV010-280 PLATE, PS FRONT,
ALT, RT10
7A375-451
3/8" x 4.5" BOLT
4PCV010-270 PLATE,
PS MIDDLE, ALT.
RT10
2A017-101-121
1.21" SPACER
4PCV010-260
PLATE, PS REAR,
ALT, RT10
4HS017-021
2A017-875-02
1.56" SPACER
2A017-875-04 3.46" SPACER
7A375-175
3/8" x 1.75" BOLT
4PCV010-290 PLATE,
DS, ALT, RT10
7A375-276
3/8" x 2.75"
BOLT
7C080-070
M8 x 70mm
BOLT
7A375-475
3/8" x 4.75
BOLT
FACTORY SMOOTH
IDLER AND
PILOT SPACER
7A017-103-110
1.10" SPACER
7A375-350
3/8" x 3.5" BOLTS
2A017-102-740
.74" SPACERS
7A375-276
3/8" x 2.75"
BOLT
M8 x 35mm
BOLT INSTALLED
THROUGH
HOLE