Paxton Superchargers Dodge Viper RT/10 - Manual (Page 9)

1-1
P/N: 4809646
©2006 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
17FEB06 v2.0 92-96Viper(4809646v2.0)
Section 1
COMPONENT REMOVAL
A. Disconnect the Idle Air Control (IAC) motor
hose and the valve cover breather hose from
the air box (air filter housing).
B. Remove all of the inlet ducting up to but not
including the throttle bodies. Remove the
two air box mounting studs from the core
support.
C. Remove the air temperature sensor from the
air box and set aside.
D. Jack the front of the vehicle up and support
with a jack stand under each frame rail.
E. Drain the engine coolant sufficiently to
remove the upper radiator hose.
F. Remove the two screws securing the power
steering cooler to the shock tower brace.
Jack the front of the vehicle up by placing a
jack under the front cross member.
G. Remove the five screws holding the shock
tower brace and remove the brace.
H. Remove the accessory drive belt.
I. Loosen the nut on the high pressure power
steering line where it enters the power steer-
ing pump.
J. Remove the three screws securing the power
steering pump to the bracket and set aside
for later use. Remove the three screws
securing the bracket to the head and remove
the bracket.
K. Remove the six 5/16" screws securing the
crank pulley to the harmonic damper and
remove the crank pulley.
L. Remove the front fascia. Close the rear of
the hood to provide access under the front of
the hood. Start by removing the mounting
screws from the bottom of the vehicle and in
the front of each wheel well. Remove the
plastic push connectors from underneath the
leading edge of the hood and from the top of
the radiator air inlet opening. Unplug the fog
and turn signal lights on each side of the
vehicle by reaching behind the front fascia.
Remove the plastic push connector securing
the front fascia to the bumper in front of and
below each headlight. Carefully remove and
set aside the front fascia.
***NOTE***
Carefully note where any alignment shims are located
and replace in the same location when the front fascia
is re-installed.
1. PREPARATION/REMOVAL