Paxton Superchargers Dodge Viper RT/10 - Manual (Page 13)

Section 3
OIL DRAIN
3-1
P/N: 4809646
©2006 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
17FEB06 v2.0 92-96Viper(4809646v2.0)
A. To provide an oil drain for the supercharger,
it is necessary to make a hole in the front of
the oil pan.
B. Remove the oil dipstick retaining screw
from the passenger’s side valve cover brack-
et.
C. Drain the engine oil.
D. Remove the oil pan.
E. The hole should be centered .5" from the
bottom of the oil pan lip as shown. Use a
center punch to mark the hole location. Use
the supplied 9/16" rota-broach to drill the
hole.
F. Tap the hole with a 3/8"NPT pipe tap.
G. Thoroughly clean the threaded area and the
inside of the oil pan. Apply a small amount
of sealer to the new threads. Apply more
sealer to the supplied 3/8"NPT x 1/2" hose
barb fitting and secure in the hole. Make
sure a seal is formed all around the fitting.
***NOTE***
Clean and inspect the oil pan gasket. If it is in good
condition it can be used again.
H. Re-install the oil pan. Torque the fasteners to
95 in-lbs (11 N-m).
I. Install a new oil filter and refill the engine
with fresh oil.
Fig. 3-a
3. OIL DRAIN