Xtramus NuDC-4U V2.1 User Manual
Page 35
35
E-mail: [email protected]
Website: www.Xtramus.com
XTRAMUS TECHNOLOGIES
®
Please note that, for the convenience of performing power tests, the accessory boards mentioned above
are not covered with outer cases. Due to this reason, it is important to handle NuDC-4U’s accessory
boards with care when performing power tests. Also, please
•
Static electricity might cause damages to NuDC-4U’s accessory boards, and should be avoided.
•
When plugging cable connectors into sockets, please do so in a vertical angle to prevent damaging
the core and pins inside the socket.
•
Please hold the connector when removing cable. Removing the cable by pulling it out from its
socket might cause damages.
•
When holding NuDC-4U’s accessory boards, please hold the edge of the accessory boards without
touching any components on the accessory boards.
•
DC jacks soldered on PCB are disposable when damaged. Please contact your distributor for
purchasing new DC jacks if you would like to replace your damaged DC jacks.
•
When using probes or alligator clips, please be aware of short circuit.
•
Before connecting NuDC-4U and its accessory boards, please make sure that all the
wiring/connection is correct.
•
NuDC-4U’s detection ranges for voltage/ampere/watt are 0.1V to 55V DC, 10mA to 8A and
0.001W
to 440W. Performing tests on DUT that’s beyond NuDC-4U’s voltage/ampere/watt
detection ranges will damage your NuDC-4U, and should be avoided
.