AMETEK ReFlex Programming Manual - Manual (Page 102)

ReFlex Power™ Programming Manual AC Module Remote Programming
98 M380056-03 Rev L
Command Description
:STATe <bool>
1
Set the initial POR output state of the unit
:STATe? Query the initial POR output state setting of the unit
:FREQuency <NRi> Set the initial frequency of the unit
:FREQuency? Query the initial frequency of the unit
:DEFault Set the initial value to default
:MODule
:LASTCAL <Date> Set the last calibration date
:LASTCAL? Query the last calibration date
:NEXTCAL <Date> Set the next calibration date
:NEXTCAL? Query the next query calibration date.
1 If CAL:INIT:STATe is ‘1’, the module will automatically turn on as if an OUTP:STATe
1 command had been received. This will only occur during initial power up, *RST will
only restore the saved CAL:INIT values. The unit will not automatically turn on if
enabled, after a *RST.