AMETEK ReFlex Programming Manual - Manual (Page 57)

M380056-03 Rev M 53
3.
DC MODULE REMOTE PROGRAMMING
3.1 INTRODUCTION
This section covers the remote programming of the ReFlex Power™
programmable DC power supplies, High Power DC (HPDC) and Low Power DC
(LPDC). This interface enables operation of the HPDC and LPDC power supplies
from a computer via the Ethernet, allowing full remote programming control and
monitoring of the power supply.
The syntax of all SCPI commands implemented by the ReFlex Power™ system
and documented in this manual, are either SCPI confirmed in the SCPI 1999.0
Specification, Volume 2: Command Reference, or they are customized
commands not part of the SCPI definition, but conform to SCPI syntax.
3.2 FEATURES AND FUNCTIONS
F EATURES
•
16-bit programming and 16-bit readback of voltage and current
•
Programmable over/undervoltage protection with reset
•
Programmable overcurrent protection
•
User selectable Constant-Voltage/Constant-Current mode, with reset
•
Field-upgradeable firmware via Ethernet
•
Soft calibration
P ROGRAMMABLE F UNCTIONS
•
Output voltage and current
•
Soft limits for voltage and current
•
Over/Undervoltage protection
•
Programmable Overcurrent trip point
•
Output enable/disable
•
Maskable fault interrupt
•
Full calibration