AMETEK ReFlex Programming Manual - Manual (Page 110)

ReFlex Power™ Programming Manual AC Module Remote Programming
106 M380056-03 Rev L
4.10 STATUS SCPI COMMANDS
4.10.1 STATUS SCPI C OMMAND S UMMARY
STATus<n>
:MODule
:ENABles <0+NR1>
:ENAB1 <0+NR1>
:ENABles?
:ENAB1?
:FAULts?
:FAULT1?
:HWREV?
4.10.2 STATUS SCPI C OMMAND R EFERENCE
Command Description
STATus<n>:MODule
:ENABles <0+NR1> Enable the supervisories register 0. Use Table 4-2 for bit definitions.
:ENAB1 <0+NR1> Enable the supervisories register 1. Use Table 4-3 for bit definitions.
:ENABles? Query the supervisories register 0
:ENAB1? Query the supervisories register 1
:FAULts? Query the module faults register 0. See Table 4-2 to decode.
:FAULT1? Query the module faults register 1. See Table 4-3 to decode.
:HWREV? Returns Hardware Rev Value.