AMETEK ReFlex Programming Manual - Manual (Page 127)

Fixed Power DC Remote Programming ReFlex Power™ Programming Manual
M380056-03 Rev L 123
6.
FIXED POWER DC REMOTE
PROGRAMMING
6.1 INTRODUCTION
This section covers the remote programming option for the ReFlex Power™
Fixed Power DC Module. This interface enables operation of the Fixed Power DC
from a computer via the Ethernet, allowing full remote programming control and
monitoring of the Fixed Power DC module.
6.2 FEATURES AND FUNCTIONS
F EATURES
•
Fixed Plus 5, Minus 5, Plus 15 and Minus 15 Volt Supply
•
SCPI compliant command set
•
Fixed Voltage Output
•
Field-upgradeable firmware via Ethernet
•
Soft calibration
P ROGRAMMABLE F UNCTIONS
•
Over/Undervoltage protection
•
Output enable/disable
•
Maskable fault interrupt
•
Full calibration
R EADBACK F UNCTIONS
•
Status and Accumulated Status registers
•
Programming error codes
•
Fault codes
•
Manufacturer, power supply model, serial number, and firmware
version identification