AMETEK ReFlex Programming Manual - Manual (Page 121)

Load Module Remote Programming ReFlex Power™ Programming Manual
M380056-03 Rev L 117
Command Description
:PROTection <NRf> Set the initial undervoltage protection value
:PROTection? Return the initial undervoltage protection value
:VOLTage
:PROTect? Get the initial over voltage protection value
:PROTect <NRf> Set the initial over voltage protection value
:INPut Calibrate Input subsystem
:CURRent Calibrate Input Current subsystem
:COUNTS <NRi> Enter the input current counts
:CALCulate Calculate the current calibration
:FIVEPOINT <1-5> <NRf> Set the input current value for each calibration point
: RANGE <bool> Change the current range
:CURRent <1-2> <NRf> Set the input current calibration points
:CONDuctance Calibrate Conductance subsystem
:COUNTS <NRi> Set the conductance counts
:CALCulate Calculate the conductance calibration
:VOLTage <1-2> <NRf> Set the input voltage calibration points
:MEASure Calibrate Measure subsystem
:OFFSET Calibrate Measure Offset subsystem
:CALCulate Calculate the voltage calibration
:UNLock <string>
Unlock the calibration data file; enables storage of the calibration
constants. The enable string is <“6867”>.
:STORe Stores the calibration constants.
:LOCK
Locks the calibration data file; disables calibration data store, thereby
preventing storage of the calibration constants.
5.7 MEASURE SCPI COMMANDS
5.7.1 MEASURE SCPI C OMMANDS S UMMARY
MEASure<n>
:CURRent?
:VOLTage?
: POWer?
5.7.2 MEASURE C OMMANDS R EFERENCE
Command DESCRIPTION
MEASure<n> MEASURE subsystem of commands
:CURRent? Returns the floating-point value of the DC input current.
:VOLTage? Returns the floating-point value of the DC input voltage.
: POWer? Returns floating point value of DC power