Artesyn SCP-P4040-4G-ENP2 Installation and Use (August 2014) - Manual (Page 15)

Chapter 1
SCP-P4040-4G-ENP2 Installation and Use (6806800P60B) 15
Introduction
The SCP-P4040-4G-ENP2 is a COM Express module based on the Freescale Power PC P40x0
platform.This board provides some of the universal interfaces such as Gigabit Ethernet, USB,
PCIE, and so on.
1.1 Features
Following are the features of the SCP-P4040-4G-ENP2:
 Form Factor: Basic (95mm x 125mm) Bullet list 2
 P4040 CPU supported
 Boot Options:
– 16 bits width NOR flash from local bus (standard product default)
– NAND flash from local bus
– I2C EEPROM
Note: Selectable via carrier
 Operating System:
– Linux
– VxWorks
Note: VxWorks is only a plan rather than requirement Supported CPU: P4040
 (P4040) dual channel laid down DDR3, 2GB per channel, ECC (with option to populate only
one channel (top) at 2GB)
 (P4040) 16 lanes of SERDES routed to COME connectors, which can be configured as PCIE,
XAUI, SRIO, SGMII
 4 UARTs or 2 DUARTs
 (P4040) 0/1/2 GE ports (option available to use this port as USB)
 (P4040) 5/4/0 USB ports
 1588 signals output to the COME connectors
 Total 3 I2C buses
 1 SPI bus with 3 chip select signals
 Connected from the SDHC pins to COME connectors