Artesyn SCP-P4040-4G-ENP2 Installation and Use (August 2014) - Manual (Page 16)

Introduction
SCP-P4040-4G-ENP2 Installation and Use (6806800P60B) 16
 Connected from the tamper detect pins to COME connectors
 8 GPI and 8 GPO to COME connectors
 On-board RTC and WDT device
 Provide both remote and local thermal sensor
 JTAG connector on module
 Aurora testing points on module
 On-board regulators supply required voltages to devices on the module
 12V and 5V standby power supplied to module from ATX-type (or other type) power
supply through COME connectors
1.2 Standard Compliances
This product meets the following standards:
Table 1-1 Standard Compliances
Standard Description
UL60950-1 EN 60950-1 IEC
60950-1 CAN/CSA
C22.2 No 60950-1 Safety requirements
CISPR 22 CISPR 24 EN55022 EN
55024 EMC Requirements on system level
ENTSI EN 300 019 Series Environmental Requirement
Directive 2011/65/EU Directive on the restriction of the use of certain hazardous
substances in electrical and electronic equipment (ROHS)
NEBS Standard GR-63-CORE
ETSI EN 300019 series Environmental requirements