Artesyn SCP-P4040-4G-ENP2 Installation and Use (August 2014) - Manual (Page 47)

Functional Description
SCP-P4040-4G-ENP2 Installation and Use (6806800P60B) 47
4.16 USB
This module consists of one USB PHY (USB3315) and one 4-ports (USB4~USB7) USB hub
(USB2514). The interface between the USB controller and USB PHY is ULPI bus, the second
group of multiplexing interface RGMII/ULPI. So the RCW should be properly set for the using of
the second group of ULPI bus.
The operating mode of the USB hub is configured by hardware strapping, and it can also be
configured by I2C bus by changing the state of the strapping pins. Hardware strapping is the
default method. The I2C bus address of the USB hub is 0x58 when configured.
Device M41T62LC6F
Function Real-time clock with
alarm interrupt,
programmable square
wave output
Package LCC8 (1.5 mm x 3.2 mm)
Oracle Number 5106837C55
Table 4-9 WDT
Characteristic Value
Vendor ST Micro
Device M41T65Q6F
Function Watchdog output
Package QFN16 (3 mm x 3 mm)
Oracle Number 5106837C56
Table 4-8 Real Time Clock (continued)
Characteristic Value