Avery Dennison SNAP Sonic Knife - Manual (Page 20)

Users Manual Sonic Knife w/500 Machine Maintenance •••• 20
Leveling the Knife Blade
9/64TH WRENCH
CAM ADVANCE SCREW
HORN
KNIFE BLADE ASS'Y
KNIFE SCREW
OUTFEED GUARD
FIGURE 7
1: Remove the Outfeed Guard.
2: Loosen the (2) Knife Screws and using a 9/64 th Wrench, advance the roller cam
until the Knife Blade assembly compresses against the Horn Surface. Make sure
the knife spring is fully compressed.
3: Tighten the (2) Knife Screws and using the 9/64 th Wrench, advance the roller cam
back up to its original home position.
Note: Exit conveyor for SNAP not shown for clarity.