Dodge 2007 Sprinter - Manual (Page 133)

132
Controls in detail
Tempmatic
3
Heating
̈ Set temperature selector control 1
( ୴ page 131) as required, but do not
turn the control below the middle posi-
tion.
̈ Set airflow control 2 (୴ page 131) as
required, but do not turn the control
below the second speed.
̈ Set the air distribution control as
shown.
̈ Close the center air vents.
̈ Close the air vents.
̈ Open the side air vents half-way and di-
rect them at the side windows.
Ventilation
This setting rapidly ventilates the vehicle
interior.
̈ Turn temperature selector control 1
( ୴ page 131) to the lowest setting
(maximum cooling).
̈ Set airflow control 2 (୴ page 131) as
required, but do not turn the control
below the second speed.
̈ Set air distribution control 5
( ୴ page 131) to h.
̈ Open as required:
ț the center air vents
ț the side air vents
ț the ventilation vents
̈ Press the ° switch.
The indicator lamp in the switch comes
on. The air-conditioning system is
switched off.
The temperature is set using temperature
selector control 1 in the control panel
( ୴ page 131).
The recommended setting for the target
temperature is 72.0 °F (22.2 °C) under
normal conditions, to which Tempmatic
adjusts as rapidly and as comfortably as
possible.
Only change the temperature in small in-
crements.
̈ To increase: turn the temperature se-
lector control clockwise.
̈ To reduce: turn the temperature selec-
tor control slightly counterclockwise.
Basic setting
N83.40-2060-31
Setting the temperature
i
If you use the basic settings for heating
or ventilating the vehicle, you will only
rarely need to adjust the temperature,
airflow and air distribution
( ୴ page 132).