Dodge 2007 Sprinter User Manual
Page 28
27
Safety
Occupant safety
2
Wearing seat belts
1 Belt sash guide (
2 Belt latch plate
3 Release button
4 Buckle
̈ Pull the belt smoothly from the seat
belt reel holder.
̈ Route the belt over your shoulder.
̈ Click belt latch plate 2 into buckle 4.
̈ Adjust the belt to the correct height if
necessary.
̈ Pull the shoulder section of the belt up-
wards to tighten the belt against your
body if necessary.
Adjusting the belt height
You can adjust the belt height for the fol-
lowing seats:
ț Driver’s seat
ț Outer co-driver’s seat
Always have seats belts that are damaged or
have been subjected to a heavy load in an
accident replaced, and their anchorages
checked, at a qualified specialist workshop
which has the necessary specialist knowl-
edge and tools to carry out the work re-
quired.
The manufacturer recommends that you use
an authorized Sprinter Dealer for this pur-
pose. In particular, work relevant to safety
or on safety-related systems must be car-
ried out at a qualified specialist workshop .
For safety reasons, the manufacturer rec-
ommends that you only use seat belts that
have been specially approved for your vehi-
cle by the manufacturer.
Warning
G
Only adjust the belt height when the vehicle
is stationary and the handbrake is applied.
You could otherwise lose control of the vehi-
cle as a result of the seat adjusting move-
ment and thereby endanger yourself and
others.