Rims and tires – Dodge 2007 Sprinter User Manual

Page 368

Advertising
background image

367

*Technical data

Rims and tires

6

̄ Rims and tires

!

CAUTION

Only use tires which have been tested

and approved for your Sprinter vehicle

by the vehicle manufacturer. Tires ap-

proved by the vehicle manufacturer are

developed to provide the best possible

performance in conjunction with the

driving safety systems on your Sprinter

vehicle such as ABS, BAS, ASR or ESP

®

.

Using tires other than those approved

by the vehicle manufacturer may result

in damage that is not covered by the

Sprinter warranty.
Using tires other than those approved

by the vehicle manufacturer can have

detrimental effects, such as
ț poor handling characteristics
ț increased noise
ț increased fuel consumption
Moreover, tires and rims not approved

by the vehicle manufacturer may, un-

der load, exhibit dimensional variations

and different tire deformation charac-

teristics that could cause them to come

into contact with the vehicle body or

axle parts. Damage to the tires or the

vehicle may be the result.

Warning

G

Loose wheel nuts or bolts could cause the

vehicle to lose a wheel while it is in motion.

This would jeopardize the operating and

road safety of the vehicle. You could lose

control of the vehicle as a result, cause an

accident an injure yourself or others.
If a wheel was replaced or new wheel nuts

are used, the wheel bolts or wheel nuts must

be retightened to the specified tightening

torque after 30 miles (50 km).
If new or repainted wheels are mounted, the

wheel bolts or wheel nuts must be retight-

ened again to the specified tightening

torque after approximately 600 to 3000

miles (about 1000 to 5000 km).

i

Further information on tires and rims is

available at any authorized Sprinter

Dealer. A placard with the recommend-

ed tire inflation pressures is located on
ț the driver’s door B-pillar for vehi-

cles with a gross weight capacity

less than 10,000 lbs (4500 kg)

(

୴ page 375)

ț on a label below the driver’s seat on

an outward facing position of the

mounting pillar for vehicles with a

gross weight capacity above

10,000 lbs (4500 kg) (

୴ page 375)

The tire inflation pressure should be

checked regularly and should only be

adjusted on cold tires.

Advertising
This manual is related to the following products: