Beisler 1225-5 - Manual (Page 18)

5.2 Foot switch machine sequence
In some of the seam programs the foot switch serves for releasing
various functions.
The foot switch is equipped with two contacts.
One of them is located at the rear and is released by stepping back.
The other one is located at the front and is released by pressure of the
heel.
5.3 Feeding the trousers parts and starting the sewing process
The overlock unit 1225/5 works semi-automatically.
The operator of the sewing unit has to do the following:
®
call up the desired seam program;
®
fuse upper fabric and knee lining at the fusing station;
® feed the workpiece precisely;
®
supervise the sewing process of the sewing unit;
®
take the finished parts out of the stacker.
Feeding the trousers part and starting the sewing process
1) Select the seam program at the control panel (see chapter 6.3).
2) Place the trousers part 1 from the right on the table top 2 and
straight underneath the contour guide 3.
ATTENTION!
As soon as the trousers part has been pushed under the light barrier 4,
the sewing process starts automatically and the contour guide 3
lowers.
14
2 1 4 3