Beisler 1225-5 - Manual (Page 44)

Maintenance work Explanation Operating
to be done hours
Pneumatic system
- Check the water level in the
pressure regulator 3
- Clean the filter insert 4
R
- Make leak test of the system
The water level must not rise up to the filter
insert 4.
- Let the water run out of the water separator
under pressure after pressing the drain
plug 5.
The filter insert 4 separates dirt and
condensed water.
- Separate the sewing unit from the
compressed air net.
- Push in drain plug 5.
The pneumatic system of the
sewing unit has to be pressureless.
- Screw the water separator 6 off
- Remove filter insert 4.
Wash the dirty filter tray and the filter insert
with benzine (no solvent!)
and blow them clean.
- Reassemble the water separator
and connect the maintenance unit.
40
500
500
40
6 5 4 3