Beisler 1225-5 - Manual (Page 79)

3.3 Adjusting the swivelling device
Caution: Risk of injury!
Switch the main switch off.
Adjust the swivelling device only with the sewing unit switched off.
Standard
The swivelling device 2 must swivel out so far that the two stamps 1
are in parallel and close position to the table top edge 3.
Correction of the swivelling width
–
Loosen nut 5.
– Shift the swivelling device correspondingly.
– Tighten nut 5.
Correction of the stamp position
–
Loosen nut 6.
– Turn stamp 1 correspondingly.
– Tighten nut 6.
21
3
3 2 1 5 4
1 6 1