Beisler 1225-5 - Manual (Page 73)

2.5.3 Presser foot
Caution: Risk of injury!
Switch the main switch off.
Check and adjust the presser foot only with the sewing unit switched
off.
Standard checking
When the feed-dogs are in their lowest position, the sole of the presser
foot should be 0.1 to 0.2 mm up at the front.
Furthermore, the needle hole of the sewing foot and that of the throat
plate should be in line.
–
Move the feed-dogs in low position.
– Check the presser foot position.
Correction
–
Loosen screws 2 and 3.
– Shift the presser foot in such a way that the needle hole of the
presser foot and that of the throat plate are in line.
– Tighten screws 2 and 3.
Take care that the sole of the presser foot is above the throat plate
in parallel position.
– Turn screw 1 in such a way that the sole of the presser foot is 0.1
to 0.2 mm up at the front.
15
3
1
3
2