Comtech EF Data CME-5000 Manual - Manual (Page 20)

Digicast Micro Encapsulator (MENCAP) Revision A
Introduction MN/MENCAPEDC.IOM
The MENCAP 50 is available in the following configurations:
•
CME-5000 Digicast MENCAP 50
Standalone Unit
• CME-5010 Digicast MENCAP 50 10K
Standalone Unit with 10,000 IP route capability
•
Digicast MENCAP 1:1 Redundancy configurations:
o CME-5100 features two CME-5000 units
o CME-5110 features two CME-5010 units
o CME-1600 Redundancy Switch featured in both configurations
1.2 Standard Features
Based on an embedded architecture, utilizing a MIPS CPU and eCOS Operating System,
the MENCAP 50 provides the following features:
•
High Reliability – supports 1:1 redundancy
•
Support for Multicast and Unicast IP datagrams
•
MPE Section Packing and Non-Section Packing on a route-by-route basis
•
Support for all valid PIDs in 8192 range
•
Support for Promiscuous Mode
•
Multicast Zones
•
IP Copy
•
1,024 Routes
•
Support for 10,000 Routes (with CME-5010 MENCAP 50 10K option)
•
QoS on a route-by-route basis (min/max bandwidth)
•
MPEG-2 188/204-byte operation
•
Aggregate throughput of 73 Mbps with 1,500 byte IP packets
•
Maximum configurable egress rate 85Mbps
•
Program Specific Information (PSI) - PAT/PMT support
•
NIT support for DVB-T, DVB-C, DVB-S
•
Basic ATSC Tables
•
ATSC A/90 data broadcast
•
ATSC A/92 IP multicast over ATSC data broadcast
•
SMPTE 325M
•
TCP to UDP for Kencast Fazzt Guaranteed File Broadcast (GFB)
•
IGMP for Multicast Route Announcements
•
Configurable Telnet and HTTP ports for security
•
Color LEDs for status monitoring and rapid fault isolation
•
Support for 802.1Q VLAN Tags
•
Management (monitor, control and configuration):
o Web Interface
o Terminal Interface
o Telnet
o TFTP for remote field software/firmware upgrade
o SNMP V2 (Private and MIB II) Support
1–2