Comtech EF Data SNM-1000 - Manual (Page 108)

SNM-1000 Node Control Modem Revision 3
Operation MN/SNM1000.IOM
3–66
3.7.18.2.1 Command Format
<channel_no> DC <circuit_id>’cr’
<channel_no> Prefix channel number.
Valid range: 1 through 30.
1 through 30 are for traffic modems attached to an SNM-1000, operating in
external traffic mode.
DC Pre-defined data circuit call.
<circuit_id> Pre-defined circuit id at the NMS.
Valid range: 1 through 9999.
3.7.18.2.2 Local Command Responses
<none> Command received OK, will be sent to the NMS.
Error <code> : <description>
Code Description
9 Channel <channel No.> Invalid
20 Not enough parameters
3.7.19 Terminate (TE)
The terminate command terminates an active call.
3.7.19.1 Command Format
<channel_no> TE'cr'
<channel_no> Prefix channel number.
Valid range: 1 through 30.
1 through 30 are for traffic modems attached to an SNM-1000,
operating in external traffic mode.
TE Terminate active call.
3.7.19.2 Local Command Responses
<none> Command received OK, will be sent to the
NMS.
Error <code> : <description> Code Description
9 Channel Invalid
24 Channel not active