Comtech EF Data SNM-1000 - Manual (Page 97)

SNM-1000 Node Control Modem Revision 3
Operation MN/SNM1000.IOM
3–55
3.7.5 Receive Control Channel Frequency (ICF)
This command sets the receive (NMS to remote) control channel IF frequency at the
remote node.
3.7.5.1 Command Format
ICF <frequency>'cr'
<frequency> Entered in MHz.
Range of 50 to 90 MHz, or 100 to 180 MHz
Resolution of 100 Hz.
Formatting is pseudo-floating point.
Example:
ICF 70.4567 sets receive control IF frequency to 70.4567 MHz.
3.7.5.2 Local Command Responses
ICF= <frequency>, <control channel offset>, <traffic channel
offset>
3.7.6 Transmit Control Channel Frequency (OCF)
This command sets the transmit (remote to NMS) control channel IF frequency at the
remote node.
3.7.6.1 Command Format
OCF <frequency>'cr'
<frequency> Entered in MHz.
Range of 50 to 90 MHz, or 100 to 180 MHz.
Resolution of 100 Hz.
Formatting is pseudo-floating point.
Example:
OCF 70.1234 sets transmit control IF frequency to 70.1234 MHz.
3.7.6.2 Local Command Responses
OCF= <frequency>, <control channel offset>, <traffic channel
offset>