Comtech EF Data SNM-1000 - Manual (Page 109)

SNM-1000 Node Control Modem Revision 3
Operation MN/SNM1000.IOM
3–67
3.7.20 Initiate Multipoint Data Call (MI)
This command initiates a multipoint data call on the specified channel. The NMS reports
call status using the CS unsolicited response.
3.7.20.1 Command Format
<channel_no> MI <phone_number> <tx_data> <tx_code> <tx_mod> <origin_clock> <rx_data>
<rx_code><rx_mod> <dest_clock> <encoder_type>'cr'
<channel_no> Prefix channel number.
Valid range: 1 through 30.
1 through 30 are for traffic modems attached to an SNM-1000, operating in
external traffic mode.
MI Initiate MultiPoint Data Call
<phone_number> Destination data channel address (phone number).
Max. length: 32 characters.
Valid characters: '1', '2', '3', '4', '5', '6', '7', '8', '9', '0', '*', '#', 'A', 'B', 'C', 'D', '-',
'(' or ')'
Note: The '-' and '('or')' characters are not part of the number and are used to
increase readability. They are stripped out and not passed to the NMS.
<tx_data> and
<rx_data> Data rates, defined in kbps.
Step size: 1 bit/s.
Maximum value: 8192.000 kbps.
Examples: 64 is 64 kbps, 64.001 is 64.001 kbps, 1024.1 is 1.0241 Mbit/s, etc.
Note: The decimal point is not required and the entered number is rounded to
the nearest 1 bit/s value.