Dish Network Solo 381 - Manual (Page 23)

Chapter 3
18
Changing Channels
C
HANGING
C
HANNELS
Using the Up and Down Arrows
While watching TV, if you want to change the channels one at a time to see
what’s on, press the UP and DOWN ARROWS on your remote control. You can
also change the channels the same way using the UP and DOWN ARROWS on
the receiver front panel.
Entering a Channel Number
While watching TV, if you know the specific channel you want to watch, enter
the channel number using the NUMBER PAD on the remote control.
Using the RCA Audio and Video Inputs
You can select the RCA Audio and Video inputs as sub-channels of Channel 0.
Select Channel 0 from the Program Guide, and then select either Input 1 or Input 2.
U
SING THE
P
ROGRAM
G
UIDE
You can use the Program Guide to see what programs are on, to change channels, and to set up
recordings. To access this guide, press GUIDE.
• A red background behind a channel usually means you have not subscribed to the channel.
After you subscribe to a channel, you can tune to it. To subscribe to a channel, call
1-800-333-DISH (3474).
• A yellow background behind a channel is for over-the-air digital channels. See page 75 for
instructions to connect an over-the-air antenna to your receiver.
381.book Page 18 Thursday, June 29, 2006 11:00 AM