Dish Network Solo 381 - Manual (Page 57)

Chapter 9
52
Controlling Other Components
3
For AUX mode only. Press 0 for a
second TV, or 1 for a second VCR,
or 2 for a tuner, or amplifier. Then press
the STAR (*) button. This step is for programming which kind of
device that should be programmed in AUX
mode. If you’re not programming in AUX mode,
skip to step 4.
4
If you want to program Limited Mode,
press PAGE UP. If not, skip to step 7. See Limited Mode for more information.
5
Press POWER. This puts your remote in the scan mode.
6
Press the UP or DOWN ARROW
repeatedly until the device turns off. As you press the UP or DOWN ARROW, the
remote tries each code in the memory to see if
it can turn off your device. When the device
turns off, you have found a code that might
work.
Note: The mode button for the device will flash
rapidly eight times when you’ve scanned all the
codes for that device.
7
Press POUND (#). The mode button flashes three times if you
have entered the code correctly. This stores the
code you found.
8
Turn the device back on and try some
other buttons to make sure they work. Press POWER to turn the device back on. Try
some other buttons to make sure they work.
Sometimes POWER works when other buttons
don’t.
9
If necessary, repeat this procedure until
you’ve tried all the codes. You may need to repeat the scan to find the
best code for your device.
Instructions Additional Information
381.book Page 52 Thursday, June 29, 2006 11:00 AM