Dish Network Solo 381 - Manual (Page 55)

Chapter 9
50
Controlling Other Components
Combination Devices
If you are programming the remote to control a combination device, such as a TV/VCR or a TV/
DVD, program the remote control in one mode, and then repeat the procedure in the other mode.
For example, to program the remote to control a TV/VCR using code 748, follow the instructions to
program the remote to control the TV using code 748, and then repeat the instructions for the VCR
using the same code.
Setting Up Using Device Code Tables
You can set up the remote to control other devices using the device codes listed on page 93. In the
instructions below, the column on the left contains the instructions and the column on the right
provides additional information.
Instructions Additional Information
1
Turn the device on. Use the device’s front panel buttons or its
remote control.
2
Find the brand name of the device in
the tables starting on page 93. If the brand isn’t listed, see Setting Up Using
Device Codes Scan on page 51.
3
Press and hold the mode button until
all the other mode buttons light up, and
then let go of the button. The mode
button flashes. For example, hold TV for a TV until all of the
other mode buttons light. When you let go, TV
will flash.
4
For AUX mode only. Press 0 for a
second TV, or 1 for a second VCR,
or 2 for a tuner, or amplifier. This step is for programming which kind of
device that should be programmed in AUX
mode. If you’re not programming in AUX mode,
skip to step 5.
5
Enter one of the three-digit device
codes from the table using the number
buttons. The three-digit device code should be for the
brand name of your device that you found in
step 2.
6
If you want to program Limited Mode,
press PAGE UP. If not, skip to step 7. See Limited Mode for more information.
381.book Page 50 Thursday, June 29, 2006 11:00 AM