Dish Network Solo 381 - Manual (Page 84)

Connections and Setup
79
QAM Installations
QAM I
NSTALLATIONS
If you live in an apartment, condominium or other clustered housing, your television signal is
transmitted to you through master multiplexing distribution equipment located in a central area in
your dwelling complex. This distribution equipment is owned and maintained by the dwelling
complex owners or managers.
Note: Do not change the setting on this screen unless otherwise directed.
U
SING
T
ROUBLESHOOTING
T
OOLS
Your receiver has diagnostic tools that a Customer Service Representative may ask you to use if
you should ever run into problems while using your equipment. Even though these tools are quite
helpful, it is recommended that you only use them when on the phone with a DISH Network
representative.
Resetting Your Receiver
Reset your receiver as directed by the Customer Service Representative as follows:
1
Press and hold the front panel POWER until the front panel light blinks once and the TV screen
goes blank.
2
Let go of the front panel POWER.
It will take a few minutes for your receiver to reset and come back on. When you reset your
receiver, your receiver will download an updated Program Guide.
381.book Page 79 Thursday, June 29, 2006 11:00 AM