Dish Network Solo 381 - Manual (Page 76)

Connections and Setup
71
Connecting to a TV
HD Display
You can change the format of the HD display output (called the aspect ratio). To choose between
the 16 x 9 widescreen format and the two 4 x 3 screen formats, as well as the output resolution:
1
Press MENU 6-1-9 and select the configuration you want.
2
Select Save.
The available display modes for the HD and the SD outputs on their displays may be selected
independently. This feature allows you to control the viewing format of programs in Normal, Grey
Bar, Stretch, Partial Zoom, or Full Zoom. To change the format, while watching TV:
• Press the PAGE UP button on the remote to change through the available options on the HD
output.
• Press the PAGE DOWN button on the remote to change through the available options on the
SD output.
Only supported options for the type of program and the output in use are displayed. You can keep
pressing the PAGE UP or PAGE DOWN button until you reach the display format you like. The
receiver will remember the last selected output format independently for each type of output and
program type. The selected display format will be displayed in the view banner when changing to a
new channel.
Screen Positioning
If you need to adjust the position of the video on the HD display screen:
1
Press MENU 6-1-9.
2
Select Adjust.
3
Use the ARROW buttons on the remote to change the vertical and horizontal positions of the video
and menu images on the screen.
4
Press SELECT/OK to save the setting.
Note: Not all HD monitors permit this feature to operate as they may provide automatic positioning
that will conflict with settings on the receiver.
381.book Page 71 Thursday, June 29, 2006 11:00 AM