Dish Network Solo 381 - Manual (Page 52)

Remote Control Setup
47
Improving Receiver Control
Checking the Remote Control Address
You can see what address is programmed on the remote control by completing the following
instructions.
1
Press and hold the SAT mode button for three seconds, until all of the mode buttons light up, and
then let go of the SAT button.
2
Press POUND (#) twice. The SAT mode button will flash the same number of times as the address
number (for example, three flashes means address 3).
Confirming Remote Control Operation
Complete the following to make sure the remote operates the receiver:
1
Make sure the remote has fresh batteries and is in SAT mode.
2
Press SYSTEM INFO on the receiver front panel to display the System Info screen.
3
Press RECORD on the remote control. The address in the System Info screen changes to match
the address preset in your remote control.
4
Press POWER on the remote control to turn on/off the receiver.
381.book Page 47 Thursday, June 29, 2006 11:00 AM