Hardware installation power-on select – DFI SR330-N User Manual
Page 29
Advertising
29
2
Hardware Installation
Power-on Select
JP13 is used to select the method of powering on the system. If you
want the system to power-on whenever AC power comes in, set
JP13 pins 2 and 3 to On. If you want to use the power button, set
pins 1 and 2 to On.
Note:
In order to ensure that power is resumed after a power failure,
JP13 should be set to pins 2-3 and the “PWRON After Pwr-
Fail” in CMOS is set to “ON”.
1-2 On:
Power-on via
power button
(default)
2-3 On:
Power-on via
AC power
JP13
X
3
1
2
3
1
2
Advertising
This manual is related to the following products: