DFI SR330-N - Manual (Page 53)

53
2
Hardware Installation
IrDA Connector
W
1 5
VCC
N. C.
IRRX
Ground
IRTX
The IrDA connector is for connecting an IrDA module. Connect the
cable connector from your IrDA module to this connector.
Note:
The sequence of the pin functions on some IrDA cable may be
reversed from the pin function defined on the system board.
Make sure to connect the cable connector to the IrDA
connector according to their pin functions.
BIOS Setting
Configure IrDA in the Integrated Peripherals submenu (“Super IO
Device” section) of the BIOS. Refer to chapter 3 for more
information.
Driver Installation
You may need to install the proper drivers in your operating system
to use the IrDA function. Refer to your operating system’s manual or
documentation for more information.