DFI SR330-N - Manual (Page 80)

80
3
BIOS Setup
PWRON After PWR-Fail
Off When power returns after an AC power failure, the
system’s power is off. You must press the Power but-
ton to power-on the system.
On When power returns after an AC power failure, the
system will automatically power-on.
Former-Sts When power returns after an AC power failure, the
system will return to the state where you left off be-
fore power failure occurs. If the system’s power is off
when AC power failure occurs, it will remain off when
power returns. If the system’s power is on when AC
power failure occurs, the system will power-on when
power returns.
Onboard Serial Port 1, Onboard Serial Port 2, Onboard Serial
Port 3 and Onboard Serial Port 4
3F8, 2F8, 3E8, 2E8 Allows you to manually select an I/O
address for the serial port.
Disabled Disables the serial port.
Serial Port 1 Use IRQ, Serial Port 2 Use IRQ, Serial Port 3 Use
IRQ and Serial Port 4 Use IRQ
These fields are used to select an IRQ for the onboard serial port 1,
2, 3 and 4.