DFI SR330-N - Manual (Page 36)

36
2
Hardware Installation
DVI-I Port
DVI-I
W
The DVI-I port is used to connect an LCD monitor. This port sup-
ports DVI-D signal only.
Connect the display device’s cable connector to the DVI port. After
you plug the cable connector into the DVI port, gently tighten the
cable screws to hold the connector in place.
Dual Display
The system board provides total of 3 display interfaces - DVI, VGA
and LVDS. The system will display maximum of 2 display devices only.
DVI-D and LVDS can display at the same time only when under
Windows operation system.
BIOS Setting
Configure the onboard DVI in the Advanced Chipset Features
submenu of the BIOS. Refer to chapter 3 for more information.